電氣石微粉氣流磨生產工藝

編號：SBJS00120

篇名：電氣石微粉氣流磨生產工藝

作者：呼振峰; 賈木欣;

關鍵詞：選礦工程; 電氣石; 氣流磨; 超細粉碎; 粒度;

機構： 北京礦冶研究總院; 北京礦冶研究總院 北京;

摘要： 研究利用QLM-Ⅳ型流化床式氣流磨生產電氣石粉體時各種工藝條件對產品細度的影響,。結果表明,當噴嘴直徑為?13mm,、分級輪轉速為3900r/min時,可以分別從旋風收料和布袋收塵得到d50=3.390μm和d50=1.961μm的電氣石微粉。通過進一步調節分級輪轉速,、噴嘴直徑,、粉碎次數等參數,可以生產出粒度分布窄,、解團聚充分、無污染的超細電氣石系列粉體,并且為后續濕法攪拌磨礦制備生產原料,。 The effect of the technical parameters on the particle size of the tourmaline powder product from the jet mill is investigated by the QLM-Ⅳ fluidized bed opposed jet mill.The results show that under the condition of the muzzles size(13mm and the rotating speed of classification wheel 3900 r/min,the powder products with d50-size 3.390μm and 1.961μm are obtained from the cyclone classifier and the hop-pocket dust collector,respectively.The tourmaline ultra-fine powders with the characters of narrow size distr...