濕法碾磨制備廢舊橡膠超細粉體的研究

編號：FTJS00417

篇名：濕法碾磨制備廢舊橡膠超細粉體的研究

作者：陳珍明;

關鍵詞：超細粉體; 磨盤碾磨; 廢舊橡膠;

機構： 孝感學院化學系 湖北孝感;

摘要： 利用磨盤型力化學反應器強大的剪切、環向應力,、擠壓,、拉伸和摩擦作用,用水作分散介質,建立濕磨粉碎方法,制備廢舊輪胎橡膠超細粉體,。結果表明:碾磨21次膠粉的粒徑可控制在0.3到5μm之間,小于1μm的膠粉達85%以上,同時濕磨膠粉在水中具有很好的分散穩定性,濕法碾磨后膠粉的親水性大大提高了,。 In this paper,using water-surfactant mixture as dispersing medium,ultra-fine waste tire rubber(WTR) powders were prepared by pan-milling in wet state,a mechanochemical route based on a complex combination of shearing,compression,stretching and friction actions.The experimental results indicated that super-fine waste tire rubber powders with diameter 0.3~5μm were prepared by pan-milling with 21 cycles,the content of particle size smaller than 1μm was more than 85%.The experimental results also showed that su...